Sony XR-CA650X Manuel d'utilisation

Fm / am cassette car stereo, 12 b, Xr-ca650x

Advertising
background image

Sony Corporation © 2003

Printed in Thailand

3-248-256-11

(1)

Equipment used in illustrations (not supplied)
Appareils utilisés dans les illustrations (non fournis)

Cautions

• This unit is designed for negative ground 12 V

DC operation only.

• Do not get the wires under a screw, or caught

in moving parts (e.g. seat railing).

• Before making connections, turn the car

ignition off to avoid short circuits.

• Connect the yellow and red power input leads

only after all other leads have been connected.

Run all ground wires to a common ground

point.

• Be sure to insulate any loose unconnected

wires with electrical tape for safety.

Notes on the power supply cord (yellow)
• When connecting this unit in combination with

other stereo components, the connected car
circuit’s rating must be higher than the sum of
each component’s fuse.

• When no car circuits are rated high enough,

connect the unit directly to the battery.

Parts Iist (1)

The numbers in the list are keyed to those in the
instructions.

Caution

Handle the bracket 1 carefully to avoid injuring
your fingers.

1

2

B

1

2

Ч

4

3

4

5

Ч

2

Power amplifier
Amplificateur de puissance

CD/MD changer
Changeur de CD/MD

Front speaker
Haut-parleur avant

Rear speaker
Haut-parleur arrière

BUS AUDIO IN

BUS CONTROL IN

Source selector
Sélecteur de source

XA-CA30

BUS CONTROL IN

BUS AUDIO IN

A

Installation/Connections

Installation/Connexions

FM/AM Cassette
Car Stereo

Connection example (2)

Notes (2-A)
• Be sure to connect the ground cord before

connecting the amplifier.

• If you connect an optional power amplifier and

do not use the built-in amplifier, the beep
sound will be deactivated.

Tip (2-B-

)

For connecting two or more CD/MD changers,
the source selector XA-C30 (optional) is
necessary.

Connection diagram (3)

1

To a metal surface of the car
First connect the black ground lead, then
connect the yellow and red power input
leads.

2

To the power antenna control lead or power
supply lead of antenna booster amplifier
Notes
• It is not necessary to connect this lead if

there is no power antenna or antenna
booster, or with a manually-operated
telescopic antenna.

• When your car has a built-in FM/AM

antenna in the rear/side glass, see “Notes on
the control and power supply leads.”

3

To AMP REMOTE IN of an optional power
amplifier
This connection is only for amplifiers.
Connecting any other system may damage
the unit.

4

To the +12 V power terminal which is
energized in the accessory position of the
ignition key switch
Notes
• If there is no accessory position, connect to

the +12 V power (battery) terminal which is
energized at all times.
Be sure to connect the black ground lead to
a metal surface of the car first.

• When your car has a built-in FM/AM

antenna in the rear/side glass, see “Notes on
the control and power supply leads.”

5

To the +12 V power terminal which is
energized at all times
Be sure to connect the black ground lead to a
metal surface of the car first.

Rotary commander RM-X4S
Satellite de commande
RM-X4S

AUDIO OUT REAR

not supplied
non fourni

*

*

1

XR-CA650X

Advertising