Tweco 30 O2 Auto-Cut - Manuel (Page 49)

Manual No. 0-4818 Auto-Cut 300
2
3-25 INSTALLATION
Installation
The Remote Arc Starter must be installed in a suitable location near the torch head. If the Arc Starter is mounted
to a gantry or to any other support subject to motion or vibration, fasten the Arc Starter to the support securely.
1. Loosen, but do not remove, the lower screws securing the cover to the Arc Starter. Remove the upper
screws securing the Cover Panel to the Arc Starter.
NOTE
A wire grounds the cover to the Arc Starter base as shown below. This wire must remain in place.
2. Remove the Cover Panel from the Arc Starter.
Art # A-09625
Lower screws
(2 per side)
Upper screws (2 per side)
Cover
Ground Wire
Cover Removal
3. If not mounting the Arc Starter on a flat, horizontal surface, then mount it so the torch coolant connections
are lower so that coolant from leaks or changing leads will not drain into the other side of the unit..