Tweco 30 O2 Auto-Cut - Manuel (Page 36)

Manual No. 0-4818 Auto-Cut 300
2
3-12 INSTALLATION
3.07 Connect Work Cable and Pilot and Negative / Torch Leads
1. Pass the ends of the work cable and pilot and negative / torch leads upward through the leads bracket at
the bottom of the power supply rear panel, and through the openings in the connections cover support
panel.
2. Refer to the illustration. Connect the leads as shown. Tighten securely. Do not overtighten.
CAUTION
The clear connections cover must remain in place.
NOTE
Negative Lead and Torch Lead are used interchangably during this operation
PILO
T
WORK
TORCH
Connection Panel
AC INPUT
L1
L2
L3
Work Lead
Torch Lead - To Remote Arc Starter
Work
Torch
Lead Connection Detail
Connections Cover
Support Panel
Art # A-07660_AB
Connections Cover
Pilot
To Cutting Table
Leads Bracket
Pilot Lead -
To Remote Arc Starter