Panasonic WV-CL834 - Manuel (Page 36)

Notes:
• Masking or adjusting the detection level is needed
to prevent malfunction under the following condi­
tions:
• When shooting an object under flickering fluores­
cent light or shooting in ELC.
• When leaves or curtains etc. are swayed by the
wind.
• When the object is lighted by lighting equipment
that constantly turns on and off.
• It takes about 0.2 seconds for the alarm signal to
reach the alarm terminal of the VCR after the cam­
era detects the object.
Because the alarm signal is multiplexed on the
video signal, it may be mistakenly interpreted by
other video equipment as a time code signal.
Therefore, when camera is not used in a
Panasonic Intelligent CCTV System select OFF to
prevent the above from occurring.
9. Lens Drive Signal Selection (LENS
DRIVE)
This item is used to select the type of auto iris lens
drive signal to be supplied to the lens from the auto iris
lens connector.
f
** CAM SET DP **
CAMERA ID OFF
ALC/ELC ADC n
SHUTTER OFF
AGC ON
SENS DP OFF
SYMC INT
WHITE HAL ATW
MOTION DET OFF 1
LENS DRIVE DC
END SET UP ENABLE
Move the cursor to the LENS DRIVE parameter.
Select DC if you are using the auto iris lens that
requires a DC drive signal.
Select VIDEO if you are using the auto iris lens that
requires a video drive signal.
-34-