Panasonic WV-CL834 - Manuel (Page 35)

Note: When you need to set MASK SET, re-adjust to
obtain the optimum amount of red and blue gain.
8. Motion Detector Setting (MOTION DET)
The motion detector detects the moving objects in the
scene by monitoring the brightness level changes. You
can select the level of sensitivity for motion detection.
When this camera is connected to a compatible intelli­
gent CCTV system, the camera transmits an alarm sig­
nal by multiplexing it \with the video signal.
1. Move the cursor to the MOTION DET parameter
and select ON.
2. Press [1], The MOTION DETECT menu appears
on the monitor screen.
f
**
CAM SET OP * *
CAMERA ZD OFF
ALC/ELC ALC n
SHUTTER OFF
AGC ON
SENS UP OFF
SYNC INT
WHITE BAL AWC n
MOTION DET OH n
LENS DRIVE DC
END SET UP ENABLE
V ______ /
** KOTIOM DETECT **
LEVEL --- 1. . .
DISPLA.Y HODEn
ALASH OM
MASK SET n
RET EMD
3.
4.
7.
9.
Move the cursor to MASK SET and press E] ■ The
MASK SET menu has 48 masks. To set MASK SET,
proceed as described in steps 2 to 4 of “ALC
mode with PRESET OFF” on page 22.
Move the cursor to the ALARM parameter, and
select ON or OFF to set the alarm in the DISPLAY
MODE.
Note: When the system controller WV-RM70, WV-
CU550 or WV-CU550A is used with this
model, select OFF for ALARM.
Move the cursor to DISPLAY MODE and press EJ
to see the current setting. The masks that detect
the brightness changes start blinking.
To raise detection sensitivity, press to return to
the MOTION DETECT menu.
To obtain the optimum detection level, move the
"I” cursor to adjust the level.
Repeat the procedures above to obtain a satisfac­
tory setting.
Move the cursor to RET and press EZI to return to
the CAM SET UP menu.
-33-