Panasonic WV-CL834 - Manuel (Page 28)

6. Synchronization Setting (SYNC)
You can select internal sync mode (INT) or line-lock
mode (LL). Additionally, this model accepts the VBS
signal (color composite video or blackburst signal) and
VS signal (BAY composite video or composite sync sig­
nal). The VD2 signal (multiplexed vertical drive signal)
with the composite video output signal from external
equipment such as a Matrix Switcher is also accept­
able.
Whenever the VD2 signal is supplied to this camera,
the camera automatically switches to the VD2 sync
mode.
1, Move the cursor to the SYNC parameter and
select line-lock(LL) or internal (I NT),
2. Press E] ■
If LL is selected, the SYNC menu appears. (If INT
is selected, the synchronization mode is automati­
cally set to internal sync pulse, and the menu is
not displayed.)
f
** CAM SET DP * *
CAMERA ID OFF n
AliC/ELC ADC “1
SHDTTER OFF
AGC ON
SENS DP OFF
SYNC INT
WHITE BAD ATW “1
HOTION DET OFF “1
t.™.«! DRIVE DC
END SET DP ENABLE
V _ _
Important Notices:
1. The priority for the sync modes is as follows.
1. Multiplexed Vertical Drive (VD2) (Highest pri­
ority)
2. Line-lock (LL)
3. Color Composite Video or Blackburst Signal
(VBS)
4. BAY Composite Video or Composite Sync
Signal (VS)
5. Internal Sync (INT) (Lowest priority)
2. When the internal sync mode is to be used, select
INT. No gen-lock input signal should be supplied
to the Gen-lock Input Connector on the rear panel.
3. Whenever the multiplexed vertical drive pulse
(VD2) is supplied to the camera from an external
equipment such as a Matrix Switcher, the camera
sync mode is automatically switched to the VD2
mode.
4. When the VBS or VS gen-lock mode is to be used
select INT from this menu and supply the gen-tock
input signal to the Gen-tock Input Connector on
the rear panel.
5. The VBS gen-lock mode has its own menu for hori­
zontal and subcarrier phase adjustments. When
the cable length of the video output or the gen­
lock input is changed, the horizontal and subcarri­
er phase must be re-adjusted.
-
26
-