Panasonic WV-CL834 - Manuel (Page 19)

* Opening the Setup Menu
Press and hold down o for a second or longer.
CAM SET UP
CAMERA ID bPP
ALC/ELC ALC “1
SHUTTER OFF
AGC OM
SENS UP OFF
SYNC INT
WHITE BAL ATW
MOTION DET OFF
LENS DRIVE DC
SET UP DISABLE
-Blinking
The CAM SET UP menu appears on the monitor as
shown above.
Check the current settings on the menu.
Refer to the sections below for a detailed description of
menu items. If you decide not to make any changes
after checking the current settings, move the cursor to
END at the start of the bottom line, and press El to
close the CAM SET UP menu and return to normal
camera picture mode.
Note: If no button is pressed for 6 minutes while the
CAM SET UP menu or any other setting menu is
displayed, displaying the menu is automatically
canceled and the mode returns to the normal cam­
era picture.
CAM SET UP
CAMERA ID OFF 1
ALC/ELC ALC “1
SHUTTER OFF
AGC ON
SENS UP OFF
SYNC INT
WHITE BAL ATW "1
MOTION DET OFF n
LENS DRIVE DC
SET UP DISABLE
• Editing the CAM SEt UP Menu
Important Notices:
When the words SET UP DISABLE appear on the
bottom line of the CAM SET UP menu, you cannot
change the currently active settings. This is to pre­
vent accidental changing of the settings.
To edit the CAM SET UP menu (change settings), use
cEi and tp or ^ and to move the cursor to SET
UP DISABLE in the bottom line.
Press
133 . SET UP DISABLE changes to SET UP
ENABLE. Move the cursor to END, then to the item(s)
you want to change.
-
17
-