Panasonic WV-CL834 - Manuel (Page 32)

2. After confirming the cursor is on LL, press C3.
The vertical phase adjustment menu appears on
the monitor.
3.
5,
6
.
Move the cursor to COARSE. The cursor starts
blinking.
Supply the video output signal of the camera to be
adjusted and the reference camera video output
signal to a dual-trace oscilloscope.
Set the oscilloscope to the vertical rate and
expand the vertical sync portion on the oscillo­
scope.
Press -d or to match the vertical phase for
both video output signals as closely as possible.
(COARSE adjustment can be incremented in 16
steps by 22.5 degrees by pressing d or .)
1 (1 - -16): 0 degree
2 (1 - -16): 22.5 degrees
I
16(1 -- 16): 337.5 degrees
Note: After the sixteenth step, the adjustment
returns to the first step.
7. Move the cursor to FINE. The cursor starts blink­
ing.
8. Press d or to match the vertical phase for
both video output signals as closely as possible.
(FINE adjustment can be made up to 22.5 degrees
by pressing d or .)
Notes:
* When the “I" cursor reaches the “+” end, it
jumps back to At the same time, COARSE
is incremented by one step to enable a contin­
uous adjustment. The reverse takes place
\when the ‘T’ cursor reaches the end.
• When d or is kept pressed for a second
or longer, the “I" cursor moves faster.
-30-