Panasonic WV-CL834 - Manuel (Page 34)

Automatic White Balance Control Mode (AWC)
In this mode, accurate white balance is obtained
within a color temperature range of approximately
2 300-10 OOOK.
Move the cursor to the WHITE BAL parameter and
select AWC -> PUSH SW.
3. When the white balance setting is completed, the
words PUSH SW stop blinking.
4. When you want to adjust the white balance manu­
ally, press to select AWC and press O ■ The
AWC menu appears on the monitor, (When ATW is
selected, pressing E3 displays the ATW menu.)
—
** CAM SET UP * «
CAMERA ID OFF
ALC/ELC ALC “1
SHUTTER OFF
AGC ON
SEWS DP OFF
SYNC ШТ
WHITE EAL AKC-»PUSH SW
MOTION DET OFF “1
LENS DRIVE DC
END SET UP ENABLE
\____________ /
CAM SET ОТ •*
CAMERA ID
AIXr/ELC
SHUTTER
AGC
SENS UP
SYWC
WRITE BAL
MOTION DET
LENS DRIVE
OFP *1
ALC 1
OFF
OH
OFF
INT
AWC "1
OFF n
DC
END SET DP ENABLE
Press d] to start the white balance setup. The
words PUSH SW start blinking to indicate that the
white balance is being set.
—
** CAM SET UP * *
CAMERA ID OFF 1
ALC/ELC ALC n
SHUTTER OFF
AGC ON
SENS UP OFF
SYNC INT
WHITE BAL AWC-»PUSH SW
MOTION DET OFF n
LENS DRIVE DC
END . SET UP ENABLE
V /
/
Blinking
Fine Adjustment for AWC (ATW) Manually
You can add the detailed setting for white balance set­
ting manually.
1. To set MASK SET, proceed as described in steps
1 to 4 of “ALC mode with PRESET OFF" on page
22.
2. Move the cursor to R.
3. Press ^ or to obtain the optimum amount of
red gain.
4. Move the cursor to B.
5.
Press ^ or to obtain the optimum amount of
blue gain.
-32-