Panasonic WV-CL834 - Manuel (Page 31)

6-2. VS Gen-lock Mode (EXT(VS))
1. Move the cursor to the SYNC parameter and
select INT.
2. Connect the coaxial cable for the composite sync
or composite BM video signal to the gen-lock
input connector,
3. Confirm that the parameter INT changed to EXT
(VS) on the menu.
Caution: The gen-lock input signal should meet
with EIA RS-170 specifications and should not
contain jitter, such as a VCR playback signal ,
as it could disturb synchroriization.
/
------------ <
------------
•• CAM SET UP ** ** CAM SET UP
CAHEBA ID OFF T CAMERA ID OFF n
A1X:/ELC ALC 1 AliC/ELC ALC T
SHUTTER OFF SHUTTER OFF
AGC OH AGC OH
SENS UP OFF
4
SENS UP OFF
SYNC INT SYNC EXT(VS)
WHITE RAX, ATW 1 WHITE BAL ATW n
MOTION DET OFF 1 MOTION DET OFF n
LENS DRIVE DC LENS DRIVE DC
END SET UP ENABLE END SET UP ENABLE
\____________
k
___________ >
4. After confirming the cursor is on EXT (VS), press
[U. The phase adjustment menu appears on the
monitor.
/---------
SYNC **
H PHASE
+
RET
\_________
5. Move the cursor to H PHASE. The cursor starts
blinking,
6. Supply the video output signal of the camera to be
adjusted and the reference gen-lock input signal
to a dual-trace oscilloscope.
7. Set the oscilloscope to the horizontal rate and
expand the horizontal sync portion on the oscillo­
scope.
8. Adjust the horizontal phase by pressing ^ or
. The adjustable range is 0 - 2,0ps.
6-3. Line-lock Sync Mode (LL)
Note: The line-lock (LL) sync mode is not available
when the camera operates on DC power.
1. Move the cursor to the SYNC parameter and
select LL.
Note: The settings in this menu can be made only
when the multiplexed vertical drive signal
(VD2) is not supplied to the camera.
-29-