Check the bat led – Rockwell Automation 1756-Lx_Mx ControlLogix Controller and Memory Board Installation Instructions Manuel d'utilisation
Page 26
Advertising
26 ControlLogix® Controller and Memory Board
Publication
1756-IN101J-EN-P - November 2004
Check the BAT LED
1. Turn on the chassis power.
2. Is the BAT LED off?
3. Check that the battery or battery module is correctly
connected to the controller.
4. If the BAT LED remains on, install another battery.
5. If the BAT LED remains on after you complete step 4, contact
your Rockwell Automation representative or local distributor.
If:
Then:
Yes
Go to “Determine Which Firmware Revisions to Use” on page 10.
No
Go to step 3.
42525
BAT LED
Advertising