Rockwell Automation 1756-Lx_Mx ControlLogix Controller and Memory Board Installation Instructions - Manuel (Page 20)

20 ControlLogix® Controller and Memory Board
Publication 1756-IN101J-EN-P - November 2004
Install a CompactFlash Card in a Series B Controller
WARNING
When you insert or remove the CompactFlash card an
electrical arc can occur. This could cause an explosion in
hazardous location installations. Be sure that power is
removed or the area is nonhazardous before proceeding.
ATTENTION
If you are NOT sure of the contents of the CompactFlash
card, before you install the card turn the keyswitch of the
controller to the PROG position. Depending on the
contents of the card, a power cycle or fault could cause
the card to load a different project into the controller.
RS232
BATTERY
PORT
1-DCD
2-RXD
4-DTR
3-TXD
5-GND
DSR-6
CTS-8
RTS-7
N/C-9
1
2
BATTERY
DATE
UP
COMPACT
FLASH
2
To
Insert 1
To Eject
1 + 2 2
1
1
1. Turn the keyswitch to
the PROG position.
5. Release the latch and make sure it slides
over the CompactFlash card.
4. Insert the CompactFlash card.
The A-B logo points left.
3. Push the CompactFlash latch
to the left.
2. Open the door of the controller.