Pioneer DCS-580 - Manuel (Page 39)

Additional information 11
39
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 11
Additional information
Optional system settings
All the available settings in the standby setup
menu are listed below. See the notes in each
section for more information about the
settings. The first setting in each section is the
default.
1 Switch the system into standby.
2 Press SHIFT+SETUP and use
/ then
ENTER to choose the setting you want to
adjust.
The available settings are shown in the front
panel display.
1
3 Use / to adjust then press ENTER to
confirm and exit.
System demo setting
Switches the automatic demo feature on or off
(this starts when you plug in for the first time):
• DEMO ON – Switches the demo feature on.
• DEMO OFF – Switches the demo feature off.
TV system setting
The default setting of this system is AUTO, and
unless you notice that the picture is distorted
when playing some discs, you should leave it
set to
AUTO. If you find picture distortion with
some discs, set the TV system to match your
country or region’s system. However, this may
restrict the kinds of disc you can watch. See
the table for the kinds of discs compatible with
each setting (
AUTO, PAL and NTSC). 2
• After using / to choose TV SYS (step
2 above), press ENTER to change the TV
system as follows:
• AUTO  NTSC
• NTSC
 PAL
• PAL  AUTO
The system automatically switches on and
you’ll see the new TV system setting in the
display after seeing
WELCOME.
3
DTS CD setting
If you play a DTS-encoded CD, you will need to
change this setting to hear the decoded signal.
• NORMAL – Regular CD playback; some
DTS-encoded CDs output a noisy signal.
• DTS-CD – Proper decoding of DTS-
encoded CDs; the beginning of regular CD
tracks may be skipped.
Key lock setting
• LOCK ON – Makes the front panel buttons
and controls inoperative.
• LOCK OFF – Restores regular use of the
front panel buttons and controls.
Note
1 The setup menu is exited automatically after 5 minutes of inactivity.
2 Most models of the newly developed countdown PAL TV system detect 50 Hz (PAL)/60 Hz (NTSC) and automatically switch
vertical amplitude, resulting in a display without vertical shrinkage. However, in some cases, the image may appear without
color. If your PAL TV does not have a V-Hold control, you may not be able to watch NTSC discs because of picture roll. If the TV
has a V-Hold control, adjust it until the picture stops rolling. On some TVs, the picture may shrink vertically, leaving black bands
at the top and bottom of the screen.
Player setting
Media Type Format NTSC PAL AUTO
DVD/Super VCD/
Video CD/DivX
Video/WMV NTSC NTSC PAL NTSC
PAL NTSC PAL PAL
CD/MP3/WMV/
MPEG-4 AAC/
JPEG/no disc — NTSC PAL NTSC or
PAL
3 You have to switch the player into standby (press  STANDBY/ON) before each change.
DCS-575_580DVD_EN.book 39 ページ ２００８年２月２９日 金曜日 午後５時４３分