MaxPower Corp Gamatronic Power+ M100 - Manuel (Page 57)

Gamatronic Electronic Industries Ltd.
POWER+ 3x208 V, User Guide, Release 2.1 49
SETUP submenu Option 9: SILICON
2> RESET LOG
Reset (clear) the controller’s history log
3> DEFAULTS
1) Restore Factory Defaults…
• Restore the controller values to the factory preset and restart the
controller – soft reset, reapplies the factory settings
2) Restore User Defaults…
• Restore the controllers user saved preset
3) Save User Defaults…
• Save the current controller settings (user preset)
5> RESET TOTAL TIME
Reset the total system up-time
6> LAST MAINT, SET
Reset the last maintenance date to the current date
The Information menu, accessed with the “ESC” key
(press and hold).
1> UPSs Stat
● Displays the status of each UPS module in the system – good or bad.
2> UPSs On/Off
● Displays whether the state is on or off for each UPS module
3> SoftWare Rev
● Displays the firmware revision for system controller and the communication
card
4> Network…
● Displays the communication card IP settings and the network faults
information
5> Dry In/Out Stat
● Displays the dry contact closed/open information for all of the input output dry
contacts
6> Alarms Status
● Displays the list of all alarms and the active ones, including each alarm’s long
name
7> Language
● System controller’s LCD panel language selection – English or Spanish
8> General
• Displays global system information:
• Software revision
• Battery current limit on or off
• Battery temperature compensation on or off
• Last maintenance date
• Site 6 digit number
• Total battery capacity
• Dc voltage setting