MaxPower Corp Gamatronic Power+ M100 - Manuel (Page 56)

Gamatronic Electronic Industries Ltd.
48 POWER+ 3x208 V, User Guide, Release 2.1
4> Dry4 Association
• Set the alarms that will trigger dry contact number 4
5> Dry5 Association
• Set the alarms that will trigger dry contact number 5
6> Dry6 Association
• Set the alarms that will trigger dry contact number 6
7> Enable / Disable Alarms
• Enable or disable specific alarms from the list of 32
6) CALIBRATION
2> Dc-I Offset removal
• Set the battery dc current to zero if not calibrated properly, must be
done before the dc-I calibration with disconnected batteries
3> Dc-I Calibration
1> Calibrate Battery #1 Current
• Set the measurement current for the first battery cabinet
(mA)
2> Calibrate Battery #2 Current
• Set the measurement current for the second battery cabinet
(mA)
3> Calibrate Battery #3 Current
• Set the measurement current for the third battery cabinet
(mA)
7) PARALLEL/STANDALONE
• Set the system operation – stand alone or parallel for more then one UPS
system
9> SC2012
1) Restart Controller
• Restart the system controller – will not affect the output voltage
2) Factory Settings
• Resets system settings to the default values and restarts the controller –
hard reset, for use on manufacturing stage usually
3) Network…
1> Set IP ADDRESS
• Set the IP address for the system communications
2> Set GATEWAY
• Set the default gateway for the system communications
3> Set MASK
• Set the subnet mask for the system communications
4> Store
• Store the communication information after changing it
5> SNMP Factor
• Set the SNMP no communication factor
4) Reset MBX
• Reset the communication card