MaxPower Corp Gamatronic Power+ M100 - Manuel (Page 45)

Gamatronic Electronic Industries Ltd.
POWER+ 3x208 V, User Guide, Release 2.1 37
5.6 First-time Startup
This section describes the procedure for starting up the Power+ for the first time,
after having completed the installation process described in the previous chapter.
8. Ensure that the maintenance bypass switch is set to NORMAL (OFF),
and that no load devices are connected to the UPS.
9. Turn the AC input and AC bypass switch ON and wait (for about 2
minutes) for the POWER+ to initialize.
When applying power to the POWER+, the system automatically runs the
startup process without a need to press the On/Off button.
10. The start-up sequence begins and the control panel displays the following
sequence. (The details may vary, depending on your application.)
11. Turn the AC input and AC bypass switch ON and wait (for about 2
minutes) for the POWER+ to initialize.
12. The start-up sequence will begin and the control panel will show the
following sequence. (The details of the display may vary from what is
shown in the illustrations below, depending on your system's particulars.)
Figure 5-8: Start-up screen 1
Figure 5-9: Start-up screen 2
Figure 5-10: Start-up screen 3
Figure 5-11: Start-up screen 4
During this step, the LEDs are also checked sequentially.