Physio-Control LUCAS - Manuel (Page 52)

52 100359-50 B, ©J OLIFE AB 2006
LUCAS TM
I NSTRUCTIONS FOR U SE G EBRUIKSAANWIJZING I NSTRUCTIONS D ’ UTILISATION
3.9 R
EMOVING
LUCAS
FROM THE PATIENT
To remove LUCAS Chest Compression System
from the patient after treatment:
1. Switch off the device by turning the ON/OFF
knob to Adjust .
2. Raise the suction cup and place the height
adjustment handle in its uppermost position.
3. If available, close the air valve, and disconnect
the air hose from the air source.
4. If a LUCAS Stabilisation Strap is attached to
LUCAS, disconnect the support cushion straps
from the device straps.
5. Disconnect the upper part of LUCAS by placing
one finger in each release ring of the handles on
the support legs and pulling these up so the
upper part releases from the back plate. Lay the
upper part carefully on the floor.
6. If the patient’s condition allows it, remove the
back plate.
Before packing LUCAS or LUCAS Stabilisation
Strap into the carrying bag, clean and, if required,
disinfect the product(s). See instructions in
Section 4.