Sony TA-E9000ES - Manuel (Page 9)

Note on video component hookups
^'ou can connoct vour T\"s audio output jacks to tlio T\'
jTV/DHS) AUDIO IN jacks on the control amplifier and
apply sound effects to the audio from the T\f In this ease,
do not connect the T\”s video output jack to the T\' (T\' /
DBS) VIDEO IN jack on the control amplifier. H*vou are
connecting a separate TV tuner, connect both the anditi
and video output jacks to the control amplifier as shown
below.
Q To connect equipment that alters the video signal
Use the PRCXTESSOR jacks. You can connect a \ ideo tiller or
priK'essor (etc.). When \ ou output the video signals input to this
unit through the PRCXTESSOR OUT jacks and input the altered
signal to the PRCXTESSCtR IN jacks, that signal is output from the
MONITOR CYUT and VIDECT REC OUT jacks (see the "Video
Signal Block Diagram" on page 48 for details).
To use the PRCXTESSOR jacks, set the CUSTOMIZE menu's
"V. PROCESSOR" parameter to "ON" (see page 38).
Vìdeo Component Hookups
Notes on S-VIDEO jacks
• When using the S-VIDECT jacks instead of the VIDEO jacks,
\ our monitor must also be connected via an S-VlDECT jack.
S-\ ideo signals are on a separate bus from the \ ideo
signals and will not be output through the VIDECT jacks.
• The S-VlDEO MC^NITCTR CYUT jack on this unit Is capable of
automaticallv switching between wide and normal screen
formats. To determine whether \ our \ ideo components and/
or monitor is compatible with automatic format switching,
refer to the instructions supplied with those components.
Required cords
Audio/video cords (not supplied)
When connecting a cord, be sure to match the color-coded pins to
the appropriate jacks on the components.
Yellow (video)
Yellow (video)
White (Daudio)^dlt: White (L/audio)
Red (R/audio) Red (R/audio)
Video cord for connecting a TV monitor (not supplied)
Yellow ^—-------Yellow
X
0
o
5'
ifi
c
■ o
r*
3-
n
n
o
3
■ o
o
3
№
3