Sony TA-E9000ES - Manuel (Page 22)

Multi-Channel Surround Setup
Rear speaker roll off frequency
REAR SP > XXXHz
tn
0
<<
5
'
IQ
l/l
C
n
O
c
3
a
V)
0
c
3
a
Initial sotfinj; ; > SO 11/
This sotting lots \ on soloot tho roll oft froqnonov for tho
low out filtor Ilf tho roar (loft and right^(X'akors.
• Tho bass fro'quoncio's lowor than tho cut off frequencv
aro di\ idod by tho bass rodiro'ction circuitry and output
from tho sub woofer or other "LARGE" speakers. In
order to pre\ ent clipping, frec]uencios below the cut off
froquoncv aro not output from tho roar speakers.
? About the roll off frequency parameters
These parameters are designed to allow you to prevent clipping
by eliminating output of low-bass frequencies from "SMALL"
speakers. Be sure to set the roll off frequencx so that clipping
does not occur from the respectix e speaker.
■ Distance unit
DIST.UNIT [meter]
Initial setting : (depends on where unit was purchased)
Lets you select either feet or meters as the unit of measure
for setting distances. 1 foot corresponds to a 1 ms
difference.
Adjusting the speaker volume
Use the remote xx hile seated in your listening pxxsition to
adjust the yolump of each speaker.
For more information regarding remxxte contrxxl
operations, refer to the separate manual "Remote
Commander" supplied xvith this unit.
1 Press ® to turn on the control amplifier.
2
Touch SOUND FIELD on the supplied remote to
display the SOUND FIELD screen.
3 Touch LEVEL on the supplied remote to display the
LEVEL screen.
4
Touch TEST TONE on the supplied remote.
You will hear the test tone from each speaker in
sequence.
5 Adjust the volume level so that the volume of the
test tone from each speaker sounds the same
when you are in your main listening position.
• To adjust the balance of the front right and front left
speakers, use the front balance controls on the
remote (or FRONT (L/R) in the LEVEL menu (page
35)).
• To adjust the balance of the rear right and rear left
speakers, use the rear balance control in the remote
(or REAR (L/R) in the LEVEL menu (page 35)).
• To adjust the volume level of the center speaker, use
the center level control on the remote (or CENTER
LEVEL in the LEVEL menu (page 35)).
• To adjust the volume level of the rear speakers, use
the rear level control on the remote (or REAR
LEVEL in the LEVEL menu (page 35)).
6
Touch EXIT on the remote again to turn off the test
tone.
Ç You can adjust the volume level of all speakers at the same
time
Turn MASTER VOLUME on the main unit or touch MASTER
VOLUME +/- on the remote.
Ç* You can output the test tone from the speaker of your choice
Normally, the test tone is output from each speaker in sequence.
However, you can use the LEVEL menu to output the test tone
from one specific speaker (see page 35).
22 GB