Sony TA-E9000ES - Manuel (Page 33)

Adjusting the Speaker Levels <LEVEL>
The LEVEL menu conUiins parameters that let you modify
the output level of each speaker and perform a variefv of
other adjustmeiits to control the sound mix. The settings
available in this menu effect all the sound fields.
9 Most of these settings can also be adjusted dffectly using
the remote. See "Adjusting the speaker volume" (page 22).
■ Test Tone
Center level
TEST TONE [LS] auto
Initial setting : automatic
Lets you turn the test tone on or off.
• AUTO outputs the test tone from each speaker in order
aufomafically.
• L (left front), C (center), R (right front), RS (right
surround), LS (left surround), or SW (sub woofer)
outputs the test tone only from the corresponding
speaker.
• The test tone can also be output using the supplied
remote. See "Adjusting the speaker volume" (page 22).
■ Front balance
FRONT L I
Initial setting: center
Lets you adjust the balance between the front left and
right speakers.
• This setting can also be adjusted directly using the
supplied remote. See "Adjusting the speaker volume"
(page 22).
■ Rear Balance
REAR L
Initial setting: center
Lets you adjust the balance between the rear left and right
speakers.
• This setting can also be adjusted directly using the
supplied remote. See "Adjusting the speaker volume"
(page 22).
CENT.LEVEL-XX.XdB
Initial setting : 0 dB
Lets you adjust level of the center speaker.
• The level can be adjusted in 1 dB steps from -20 dB to
+10 dB.
• This setting can also be adjusted directly using the
supplied remote. See "Adjusting the speaker volume"
(page 22).
■ Rear level
REAR LEVEL-XX.XdB
Initial setting : 0 dB
Lets you adjust level of the rear (left and right) speakers.
• The Ibx'el can be adjusted in 1 dB steps from -20 dB to
+10 dB.
• This setting can also be adjusted directly using the
supplied remote. See "Adjusting the speaker volume"
(page 22).
■ Sub woofer level
SUB WOOFER -XX.XdB
Initial setting : 0 dB
Lets you adjust the level of the sub woofer.
• The level can be adjusted in 1 dB steps from -20 dB to
+10 dB.
■ LFE (Low Frequency Effect) mix level
LFE MIX-XX.XdB
Initial setting : 0 dB
This parameter lets you attenuate the level of the LFE
(Low Frequency Effect) channel output from the sub
woofer without effecting the level of the bass frequencies
sent to the sub woofer from the front, center or rear
channels via the Dolby Digital (AC-3) bass redirection
circuitry.
• The level can be adjusted in 1 dB steps from -20 dB to
0 dB (line level). 0 dB outputs the full LFE signal at the
mix level determined by the recording engineer.
• Selecting OFF mutes the sound of the LFE channel from
the sub woofer. However, the low frequency sounds of
the front, center, or rear speakers are output from the
sub woofer according to the settings made for each
speaker in the speaker setup (page 18).
vt
A
a
3
Ifi
VI
at
3
a
>
c
ft
3
A
3
35 QB