Blodgett MT3855G-G - Manuel (Page 25)

Maintenance
21
Cleaning
11. Move the oven to clean underneath. DO NOT
damage the gas hose or electrical cords when
moving.
12. Reverse steps 1---7 to reassemble. Be sure
the diverters and nozzles are installed correct-
ly. Refer to Figure 24.
Right Diverter Left Diverter Inner Diverter
Air Diverters --- Bottom View
Clip
Left Diverter
Inner Diverter
Right Diverter
Top View
M7106
M7105
Top View
Nozzle M7105 ---
1 hole in flange at
open end
Nozzle M7106 ---
2 holes in flange
at open end
Figure 24
Every 12 Months:
A factory authorized service person should:
1. Open and clean the inside of the control panel.
2. Check and tighten all electrical connections.
3. Check DC gear motor brushes for wear.
4. Check conveyor drive chain for cleanliness
and proper lubrication.
If maintenance is required contact your local ser-
vice company, a factory representative or the
Blodgett Oven company.
WARNING!!
Always disconnect the power supply be-
fore cleaning or servicing the oven.
WARNING!!
If the oven needs to be moved, the gas
must be turned off and disconnected from
the unit before removing the restraint. Re-
connect the restraint after the oven has
been returned to its original location.