Blodgett MT3855G-G - Manuel (Page 24)

Maintenance
20
Cleaning
4. Remove both lower end plugs.
5. Remove the conveyor assembly as follows:
a.) Remove the 1/4” thumb screw holding the
conveyor to the control box.
b.) Slide the conveyor into the oven slightly.
Remove the drive chain from the conveyor
drive sprocket.
c.) Slide the conveyor assembly out from the
control box end.
NOTE: Raise the far end of the conveyor to
clear the conveyor guides. Handle the
conveyor carefully to avoid pinching
while folding.
Figure 20
6. Remove the nozzles as follows:
a.) Remove the bolt from the hold down
bracket. Lift the bracket straight up and
slide out either end of the oven.
Figure 21
b.) Push the nozzles toward the back wall of
the oven. Lift the front end and turn it to-
ward you slipping the back end from the
duct.
Figure 22
7. Remove the return air diverters. Lift the front
end of each diverter. Slide the end clips from
under the outer edge of the oven’s back wall.
Figure 23
8. Soak the conveyor assembly in a hot water/
detergent mix.
9. Clean the crumb pans, nozzles , air plates, di-
verters and end plugs with a hot water/deter-
gent mix. Rinse with clean water. For difficult
cleaning use a heavy duty degreaser or oven
cleaner that is safe for aluminum.
NOTE: DO NOT immerse the end plugs. They
contain insulation.
10. Clean the oven interior with an all purpose
cleaner or an oven cleaner that is safe for alu-
minum.