Rack cleaning – Bosch HSLP451UC Manuel d'utilisation

Page 31

Advertising
background image

English 29

DO NOT press ENTER before following the instructions
below:

Descale Phase (cycle 2, approximately 20 seconds)
7. Remove the water tank and wash it out thoroughly. Fill

it with water and slide it back in.
— If the water tank is not refilled and the ENTER

button is pressed, the action will be ignored. The
rinse cycle can only be completed if the water tank
is refilled.

8. Wipe any remaining water from the evaporator dish

with a cleaning sponge. Wipe out the oven. Thoroughly
rinse out the cleaning sponge.

9. Press ENTER to start the first rinse cycle.

— The display will show 1ST RINSE. The countdown

will resume, and after a short time (about 20
seconds), a beep will signal the end of the first
rinse.

— The display will show CLEAN DISH and PRESS

ENTER BUTTON.

10. After 20 seconds, a beep will signal the end of the first

rinsing cycle.
— The display will show CLEAN DISH on the first line

and PRESS ENTER BUTTON on the second line.

11. Wipe any remaining water from the evaporator dish

with a cleaning sponge.

Rinse Phase (cycle 3, approximately 20 seconds)
12. Press ENTER to start the second rinse cycle.

— The display will show 2ND RINSE. The countdown

will resume again.

— After 20 seconds, a beep will signal the end of

DESCALE. The display will show DESCALE
FINISHED and CLEAN DISH.

13. Wipe any remaining water from the evaporator dish

with a cleaning sponge. Wipe out the oven. Thoroughly
rinse out the cleaning sponge.

14. Dry the oven cavity with a soft cloth.

Rack Cleaning

Removing racks
1. Carefully press the front of the rack up until it unhinges

and release it sideways from the bracket (image

A).

2. Unhinge the rack from the bracket and remove it

(image

B).

3. Clean racks with dish detergent and dish sponge/brush

or clean racks in the dishwasher.

Reinserting racks
1. Insert the rack with the indentations facing up. The

racks each only fit on one side.

2. Hook rack in back and push it back until it engages

(image C).

3. Hook rack on the front bracket and press down until it

engages and is horizontally secured in the appliance
(image D).

$

%

&

'

Advertising