Bosch HSLP451UC - Manuel (Page 30)

English 28
8. Press ENTER to begin steam cleaning.
— The display will show EXPOSURE PHASE and
exposure time of 10 minutes. The display will start
counting down from 10:00 to 0:00. The display will
then show STEAM CLEANING and a total time of
20 minutes. Countdown from 20:00 to 0:00 will
begin.
— If the door is opened for less than 30 seconds while
the mode is running, the cleaning mode will pause
and the oven timer countdown will suspend. When
the door is closed, the mode and oven timer will
resume.
— If the door remains open for more than 30 seconds,
the steam clean cycle will need to be restarted.
At the end of the cleaning phase, the countdown will
suspend and an alarm will sound. The display will prompt
the user to refill the water tank and select the ENTER
button to continue.
DO NOT press ENTER before following the instructions
below:
Cleaning Phase (cycle 2, approximately 20 minutes)
9. Refill the water tank then slide it back in.
— If the water tank is not refilled and the ENTER
button is pressed, the action will be ignored. The
rinse cycle can only be completed if the water tank
is refilled.
10. Remove the rack rails from the oven and clean
softened food residues from them (see “Rack
Cleaning” on page
29).
11. Wipe out the food residues from the oven and the
evaporator dish with a cleaning sponge, thoroughly
wash out the cleaning sponge.
12. Press ENTER to start the rinse.
— The display will show 1ST RINSE. The countdown
will resume, and after a short time (about 20
seconds), a beep will signal the end of the first
rinse.
— The display will show CLEAN DISH and PRESS
ENTER BUTTON.
13. Wipe out the evaporator dish with a cleaning sponge.
Thoroughly rinse out the cleaning sponge.
Rinse Phase (cycle 3, approximately 20 seconds)
14. Press ENTER to start the second rinse cycle.
— The display will show 2ND RINSE. The countdown
will resume, and after another 20 seconds a beep
will signal the end of STEAM CLEAN. The display
will show STEAM CLEAN FINISHED and CLEAN
DISH.
15. Wipe any remaining water from the evaporator dish
with a cleaning sponge. Wipe down the oven.
Thoroughly rinse out the cleaning sponge.
16. Dry the oven cavity with a soft cloth.
Descale
Unless you use softened water, you will need to descale
the steam oven at regular intervals. Descaling includes an
exposure, two descaling phases, and two rinse cycles, with
a total time of 30-35 minutes.
If the number of hours of operation is exceeded, the
“Descale Needed” message will be displayed each time
when a new heating mode is selected. Select ENTER to
continue. After the Descaling operation is finished, the
operation hour counter will be reset and the message will
no longer be displayed.
You can start descale only when the oven is set to OFF
and it is completely cooled down.
IMPORTANT:
Descaling requires 3 start/stop cycles to complete its
operation. Once started, the Descaling operation cannot be
aborted. The appliance will not operate again until after the
first and second rinse cycle to ensure that no cleaning
agent remains inside.
NOTE:
If the door is opened for less than a minute while the mode
is running, the mode will pause and the oven timer
countdown will suspend. When the door is closed, the
mode and oven timer will resume. If the door remains open
for more than 30 seconds, the mode will spool back to the
beginning and the descale cycle will start from the
beginning.
Exposure Phase (cycle 1, approximately 10 minutes)
1. Use only the descaling powder recommended for this
oven (BSH part number 00573828).
— Obtain from your retailer or order from www.bosch-
home.com/us/store),
2. Mix the descaling solution according to the package
instructions.
3. Empty the water tank and refill it with the descaling
solution. Return water tank to tank duct.
4. Select SETTINGS on the control panel.
5. Navigate to DESCALE.
6. Press ENTER to begin descaling.
— The display will show EXPOSURE PHASE and
exposure time of 10 minutes. The display will start
counting down from 10:00 to 0:00. The display will
then show DESCALE and a total time of 20
minutes. Countdown from 20:00 to 0:00 will begin.
At the end of the descaling phase, the countdown will
suspend and a buzzer will sound. The display will prompt
the user to refill the water tank and select the ENTER
button to continue.