Controlled Products Systems Group BX-243C - Manuel (Page 27)

26
MAINTENANCE CHART
MAINTENANCE
NOTES:
• Severe or high cycle usage will require more frequent maintenance checks.
• Limits may have to be reset after any major operator adjustments.
• If lubricating chain, use only lithium spray. Never use grease or silicone spray.
• It is suggested that while at the site voltage readings be taken at the operator.
Using a digital voltmeter, verify that the incoming voltage to the operator it is
within ten percent of the operator’s rating.
Disconnect all power to the operator before servicing. ALWAYS disconnect the batteries to service the operator.
MAINTENANCE CHART
DESCRIPTION TASK CHECK AT LEAST ONCE EVERY
MONTH 6 MONTHS
Entrapment Protection Devices Check and test for proper operation X
Warning Signs Make sure they are present X
Manual Disconnect Check and test for proper operation X
Drive Chain and Pulley Check for excessive slack and lubricate X
Gate Inspect for wear or damage X
Accessories Check all for proper operation X
Electrical Inspect all wire connections X
Mounting Bolts Check for tightness X
Operator Inspect for wear or damage X