Wiring, Power wiring, Wire the entrapment protection devices – Controlled Products Systems Group BX-243C Manuel d'utilisation

Page 19: Rx tx

Advertising
background image

18

POWER WIRING

1

Connect 120 Vac to L-N terminals on the electronic card, 50/60Hz frequency

maximum.

The electronic card is equipped with an amperometric sensor which constantly

monitors the motor’s drive. If the gate encounters an obstacle, the sensor

immediately detects the overload on the operator and the gate reverses.
Do not apply AC power until instructed.

M N

L2T

L1T

0

17

26

10 11 E1 1

2 3P 5

7

2 C1 C3 C7 C8 TS

+ E

FC FA F

LINE FUSE

230V=1 6A F

120V=3 15A F

C BOARD

FUSE

1A F

ZN5U

ZN5

CONTROL BOARD

1

M N

L2T

L1T

L N

0

17

26

10 11 E1 1

2 3P 5

7

2 C1 C3 C7 C8 TS

+ E

FC FA F

120 Vac Power, 50/60Hz Frequency

WIRE THE ENTRAPMENT PROTECTION

DEVICES

An entrapment protection device such as photoelectric sensors or an edge MUST be

wired to the operator and then configured for your application. NOTE: If entrapment

protection devices are not used, you must jumper the connections to disable the

contacts.

PHOTOELECTRIC SENSOR CONFIGURATIONS

“OPENING DURING CLOSING” (N.C.) CONTACT
If contact is opened while the gate is closing, the gate reverses direction. To select this

function set the number 9 functionality switch to OFF (refer to the "Functionality

Switches" chart on page 22). Default is OFF. To disable this function set the number

9 functionality switch to ON.

“PARTIAL STOP” (N.C.) CONTACT
Gate stops if moving and automatically shuts (if this function has been selected). To

select this function set the number 10 functionality switch to OFF (refer to the

"Functionality Switches" chart on page 22). Default is OFF. To disable this function

set the number 10 functionality switch to ON.

“CLOSE WHILE OPENING” (N.C.) Contact
This input functions to reverse the gate to the close limit when the photoelectric

sensor is activated during the opening cycle.
NOTE: If not used, short circuit contact 2-C8.

POWER WIRING + WIRE THE ENTRAPMENT PROTECTION DEVICES

WIRING

  %   0 



 # # # # 43

RX

TX

DIR10 Photoelectric Sensors: Partial Stop

  %   0 



 # # # # 43

RX

TX

DIR10 Photoelectric Sensors: Opening During Closing

  %   0 



 # # # # 43

RX

TX

DIR10 Photoelectric Sensors: Close While Opening

Advertising
Ce manuel est liée aux produits suivants: