Controlled Products Systems Group BX-243C - Manuel (Page 26)

25
Antenna
INSTALL AND PROGRAM THE
SECURITY+ 2.0™ RADIO CARD
1
Connect the antenna.
2
Disconnect all power to the operator including the batteries.
3
Insert the Security+ 2.0™ radio card into the slot on the electronic card.
4
Connect power.
NOTE: The electronic card picks up the Security+ 2.0™ radio card when the
operator is powered up.
5
Press the button on the Security+ 2.0™ radio card (the LED will light).
6
Press the button on the remote control (the LED on the radio card will go out if
programming is successful).
7
Press and hold the PROG button on the electronic card (the LED will flash).
8
Press the button on the remote control again (the LED on the electronic card
will go out).
To program additional remote controls follow steps 5 and 6 above only.
INSTALL AND PROGRAM THE SECURITY+ 2.0™ RADIO CARD
PROGRAMMING
M N L2T L1T 0 17 26 10 11 E1 1 2 3P 5 7 2 C1 C3 C7 C8 TS + E - FC FA F
L NE FUSE
230V=1 6A F
120V=3 15A F
MOTOR FUSE
BX243=8A F
BX246=10A F
ACCESSORIES
FUSE
1 6A F
C BOARD
FUSE
1A F
+ RUN S - + SLOW S - + RU
ZN5
CONTROL BOARD
PWR
1
C1
C3
ON
2 1 3 4 5 6 7 8 9 10
ROG
M N L2T L1T L N 0 17 26 10 11 E1 1 2 3P 5 7 2 C1 C3 C7 C8 TS + E - FC FA F
C7
C8
ZN5U
LED
PROG Button
Remote
Control
Security+ 2.0™ Card
ERASE THE SECURITY+ 2.0™ RADIO CARD MEMORY
1
Press and hold the button on the Security+ 2.0™ radio card until the LED goes
out (approximately 6 seconds). The memory is now erased.
NOTICE: This device complies with Part 15 of the FCC rules and Industry Canada (IC) licence-exempt RSS-210. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
This Class B digital apparatus complies with Canadian ICES-003.