Roland ARX-01 - Manuel (Page 48)

48
22: STEP FLANGER
This is a flanger in which the flanger pitch changes in steps. The speed at
which the pitch changes can also be specified in terms of a note value
based on a specified tempo.
fig.MFX22
23: OVERDRIVE
Creates a soft distortion similar to that produced by vacuum tube amplifiers.
fig.MFX23
24: DISTORTION
Produces a more intense distortion than Overdrive. The parameters are the
same as for “23: OVERDRIVE.”
fig.MFX24
Parameter Value Description
Pre Delay
0.0–100.0
ms Adjusts the time until the flanger sound is
heard.
Rate #1
0.05–
10.00 Hz, note
Frequency of modulation
Depth 0–127 Depth of modulation
Feedback #2 -98– +98 %
Adjusts the amount of the flanger sound
that’s fed back into the effect. Negative (-
) settings invert the phase.
Step Rate #3
0.10–
20.00 Hz, note
Rate (period) of pitch change
Phase 0–180 deg Spatial spread of the sound
Low Gain -15– +15 dB Gain of the low frequency range
High Gain -15– +15 dB Gain of the high frequency range
Balance #4
D100:0W–
D0:100W Volume balance between the direct
sound (D) and the flanger sound (W)
Level 0–127 Output level
R in R out
L in L out
Feedback
Feedback
Balance W
Balance D
Balance W
Balance D
2-Band
EQ
2-Band
EQ
Step Flanger
Step Flanger
Parameter Value Description
Drive #1 0–127
Amount of distortion
Also changes the volume.
Tone #2 0–127 Sound Quality
Pan #4 L64–63R Stereo location of the OVERDRIVE output
Amp Sw OFF, ON Amp simulator on/off
Amp Type #3
SMALL,
BUILT-IN,
2-STACK,
3-STACK
Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double-stack amp
3-STACK: large triple-stack amp
Low Gain -15– +15 dB Gain of the low frequency range
High Gain -15– +15 dB Gain of the high frequency range
Level 0–127 Output level
Amp
Simulator
2-Band
EQ
L in
R in
Over
drive
L out
R out
Pan R
Pan L
L in
R in
L out
R out
Pan R
Pan L Amp
Simulator
2-Band
EQ
Distortion
ARX-01_e.book 48 ページ ２００８年２月１９日 火曜日 午後４時７分