Roland ARX-01 - Manuel (Page 52)

52
29: GATE
Cuts the reverb’s delay according to the volume of the sound sent into the
effect. Use this when you want to create an artificial-sounding decrease in
the reverb’s decay.
fig.MFX29
Shuffle 0–127
Timing of volume changes in levels for
even-numbered steps (step 2, step 4, step
6...).
The higher the value, the later the beat
progresses.
Level 0–127 Output level
Step 01–16 0–127 Level at each step
Parameter Value Description
Parameter Value Description
Threshold #1 0–127
Volume level at which the gate begins to
close
Mode
GATE,
DUCK
Type of gate
GATE: The gate will close when the vol-
ume of the original sound decreases, cut-
ting the original sound.
DUCK (Ducking): The gate will close when
the volume of the original sound increas-
es, cutting the original sound.
Balance D100:0W–
D0:100W Volume balance between the direct
sound (D) and the effect sound (W)
Attack Time #2 0–127
Adjusts the time it takes for the gate to ful-
ly open after being triggered.
Hold Time #3 0–127
Adjusts the time it takes for the gate to
start closing after the source sound falls
beneath the Threshold.
Release Time #4 0–127
Adjusts the time it takes the gate to fully
close after the hold time.
Level 0–127 Output level
L in
R in
L out
R out
Gate
Gate
ARX-01_e.book 52 ページ ２００８年２月１９日 火曜日 午後４時７分