Roland ARX-01 - Manuel (Page 53)

53
30: LOFI NOISE (Lo-Fi Noise)
In addition to a lo-fi effect, this adds various types of noise such as white
noise and disc noise.
fig.MFX30
Parameter Value Description
LoFi Type #1 1–9
Degrades the sound quality. The sound
quality grows poorer as this value is in-
creased.
Post Flter Type OFF, LPF,
HPF
Type of filter
OFF: no filter is used
LPF: cuts the frequency range above the
Cutoff
HPF: cuts the frequency range below the
Cutoff
Post Filter Cutoff 200–8000 Hz Center frequency of the filter
W/P Noise Type WHITE, PINK
Switch between white noise and pink
noise.
W/P Noise
LPF 200–8000
Hz, BYPASS
Center frequency of the low pass filter ap-
plied to the white/pink noise (BYPASS:
no cut)
W/P Noise
Level #2
0–127 Volume of the white/pink noise
R in R out
L in L out
Lo-Fi
Lo-Fi
Noise Gen.
Disc Noise Type
LP, EP, SP,
RND
Type of record noise
The frequency at which the noise is heard
depends on the selected type.
Disc Noise LPF
200–8000
Hz, BYPASS
Adjusts the cutoff frequency of the low
pass filter applied to the record noise. If
you don’t want to filter out any high fre-
quencies, set this parameter to BYPASS.
Disc Noise Level
#3
0–127 Volume of the record noise
Hum Noise Type 50Hz, 60Hz Frequency of the hum noise
Hum Noise LPF
200–8000
Hz, BYPASS Center frequency of the low pass filter ap-
plied to the hum noise (BYPASS: no cut)
Hum Noise Level
#4
0–127 Volume of the hum noise
Balance
D100:0W–
D0:100W Volume balance between the direct
sound (D) and the effect sound (W)
Level 0–127 Output level
Parameter Value Description
ARX-01_e.book 53 ページ ２００８年２月１９日 火曜日 午後４時７分