Roland ARX-01 - Manuel (Page 51)

51
27: LIMITER
Compresses signals that exceed a specified volume level, preventing
distortion from occurring.
fig.MFX27
28: SLICER
By applying successive cuts to the sound, this effect turns a conventional
sound into a sound that appears to be played as a backing phrase. This is
especially effective when applied to sustain-type sounds.
fig.MFX28
Parameter Value Description
Release #1 0–127
Adjusts the time after the signal volume
falls below the Threshold Level until com-
pression is no longer applied.
Threshold #2 0–127
Adjusts the volume at which compression
begins
Ratio #3
1.5:1, 2:1, 4:1,
100:1
Compression ratio
Post Gain #4 0–18 dB Adjusts the output gain.
Low Gain -15– +15 dB Gain of the low frequency range
High Gain -15– +15 dB Gain of the high frequency range
Level 0–127 Output level
L in
R in
L out
R out
Limiter
2-Band EQ
2-Band EQ
Limiter
Parameter Value Description
Rate #1
0.05–
10.00 Hz, note Rate at which the 16-step sequence will
cycle
Attack #2 0–127
Speed at which the level changes be-
tween steps
Input Sync Sw OFF, ON
Specifies whether an input note will
cause the sequence to resume from the
first step of the sequence (ON) or not
(OFF)
Input Sync Thresh-
old
0–127
Volume at which an input note will be de-
tected
Mode
LEGATO,
SLASH
Sets the manner in which the volume
changes as one step progresses to the
next.
LEGATO : The change in volume from one
step’s level to the next remains unaltered.
If the level of a following step is the same
as the one preceding it, there is no
change in volume.
SLASH : The level is momentarily set to 0
before progressing to the level of the next
step. This change in volume occurs even if
the level of the following step is the same
as the preceding step.
L in
R in
L out
R out
Slicer
Slicer
ARX-01_e.book 51 ページ ２００８年２月１９日 火曜日 午後４時７分