Confirmation after installation – Roland ARX-01 Manuel d'utilisation

Page 11

Advertising
background image

11

After you’ve finished installing the expansion board, you will need
to perform the following procedure to confirm the installation.
This installation procedure needs to be performed only the first time
you power up your device after installing the expansion board.

1.

Power up your device as described in its owner’s
manual.

2.

If the expansion board was installed correctly, an
installation confirmation screen will appear.
Press [F8 (Execute)] button to begin installation.

* The screen shown here is for when the board is installed in the

Fantom-G.

If the installation confirmation screen does not appear the first
time you power up after installing the expansion board, it is
likely that the board was not installed correctly. Check once
again to make sure that the board is correctly installed.

It may take five to ten minutes before installation is finished.
Never turn off the power during this installation process.

3.

When you see the Power Off screen indicating that
installation is finished, switch your device’s power off,
then on again as described in its owner’s manual.

This completes the expansion board installation process.

Confirmation after installation

ARX-01_e.book 11 ページ 2008年2月19日 火曜日 午後4時7分

Advertising
Ce manuel est liée aux produits suivants: