Roland ARX-01 - Manuel (Page 63)

63
44: REVERSE DELAY
Adds the reverse of the input sound as a delay.
fig.MFX44
45: SHUFFLE DELAY
Adds a shuffle to the delay sound, giving the sound a bouncy delay effect
with a swing feel.
fig.MFX45
Parameter Value Description
Threshold 0–127
Volume level at which the reverse delay
begins
Delay 1–4
(Delay 1 #1) 0-2000 ms,
note Adjusts the time until Delays 1–4 are
heard.
Feedback 1 #2
-98– +98 %
Adjusts the amount of the delay sound
that’s fed back into the effect. Negative (-
) settings invert the phase.
Feedback 4
HF Damp 1
200–8000 Hz,
BYPASS
Adjusts the frequency above which sound
fed back to the effect is filtered out. If you
do not want to filter out any high frequen-
cies, set this parameter to BYPASS.
HF Damp 4
Pan 1–3
(Pan 1 #3)
L64–63R Stereo location of Delays 1–3 sound
Level 1–3 0–127 Output level of Delays 1–3 sound
Balance #4
D100:0W–
D0:100W Volume balance between the direct
sound (D) and the effect sound (W)
Low Gain -15– +15 dB Gain of the low frequency range
High Gain -15– +15 dB Gain of the high frequency range
Level 0–127 Output level
Feedback 1
L in
R in
L out
R out
2-Band
EQ
2-Band
EQ
D1
Delay
D3
D2
D4
Feedback 4
Rev. Delay
1
2
3
Parameter Value Description
Delay #1 0–4000 ms, note
Adjusts the time until the delay sound is
heard.
Shuffle Rate #2 0–100 %
Adjusts the ratio (as a percentage) of the
time that elapses before Delay B sounds
relative to the time that elapses before the
Delay A sounds.
When set to 100%, the delay times are
the same.
Pan A/B L64–63R Stereo location of Delay A/B
Level Balance
A100:0B–
A0:100B Volume balance between Delay A and
Delay B
Feedback #3 -98– +98 %
Adjusts the amount of the delay that’s fed
back into the effect. Negative (-) settings
invert the phase.
Acceleration 0–15
Adjusts the time over which the Delay
Time changes from the current setting to
its specified new setting.
HF Damp
200–8000
Hz, BYPASS
Adjusts the frequency above which sound
fed back to the effect is filtered out. If you
don’t want to filter out any high frequen-
cies, set this parameter to BYPASS.
Feedback
L in
R in
Delay
L out
R out
2-Band
EQ
2-Band
EQ
Delay A
Delay B
A
B
ARX-01_e.book 63 ページ ２００８年２月１９日 火曜日 午後４時７分