Panasonic PT DW10000U - Manuel (Page 36)

36 – ENGLISH
Powering off the projector
# Press POWER STANDBY “ ”.
A confirmation screen will appear.
$ Press ◄ or ► to select “OK” and
press ENTER.
(or press POWER STANDBY “ ”
again.)
The projection of the image stops, and the
power indicator lamp of the main unit lights up
orange. (The cooling fan keeps running.)
% Wait until the power indicator
lamp of the main unit turns to
red (i.e., until the cooling fan
stops). (Approx. 3 minutes)
While the cooling fan is still running, never turn
off the MAIN POWER switch, nor unplug the
projector from the outlet.
& Press the “ ○” marked side of the
MAIN POWER switch to remove
all power from the projector.
•
•
•
POWER OFF
CHANGE
EXECUTE
ENTER
OK CANCEL
POWER OFF
CHANGE
EXECUTE
ENTER
OK CANCEL
Note
Turning on the power supply will not light up the light
source lamp if the lamp is in the process of cooling
down after turning off the power supply. To light up
the lamp, turn on the power supply again when the
lamp has been cooled sufficiently.
The projector consumes approximately 25 W of
power even in standby mode. (Power indicator lamp
lit in red)
If you re-power the projector after shutting off the
main power inadvertently, the projection lamp may
remain unlit. Please turn the power on again after a
while.
•
•
•
Be sure to set the date and time when
the projector is turned on for the first
time after being purchased. For details,
refer to “Setting the date and time” on
page 81. Be sure to set the date and time when
the projector is turned on for the first
time after being purchased. For details,
refer to “Setting the date and time” on
page 81.
Projection (continued)
% # $
#
$
&