Basic operation, Projection, Power indicator lamp – Panasonic PT DW10000U Manuel d'utilisation

Page 34: Connecting the power cord, English

Advertising
background image

34

– ENGLISH

Projection

Power indicator lamp

This shows the power supply status. Make sure
that you fully understand the operation of the power
indicator lamp before operating the projector.

Attention

While the projector is in standby preparation mode
(when the power indicator lamp is lit orange), the
internal fan is running to cool down the projector. Do
not turn off the MAIN POWER switch or disconnect
the power cord at this time.

Note

If the POWER ON “ | ” button is pressed while the
projector is still in standby preparation mode, it may
take some time before the projector is ready to
project pictures.

The cooling fan will still be operating and the
projector will still be drawing approximately 25 W of
power while the projector is in standby mode (when
the power indicator lamp is lit red).

Indicator

status

Projector status

Off

Main power is off

Red

Lit

Standby mode

POWER ON (|) button can be pressed

so that images can be projected.

Green

Lit

Images are being projected (on)

Orange

Lit

Standby preparation mode

After a short while, the projector will

switch to standby mode.

Indicator

status

Projector status

Off

Main power is off

Red

Lit

Standby mode

POWER ON (|) button can be pressed

so that images can be projected.

Green

Lit

Images are being projected (on)

Orange

Lit

Standby preparation mode

After a short while, the projector will

switch to standby mode.

Connecting the power
cord

Insert the accessory power cord securely into the
projector and the electrical outlet.
Be sure to read the “IMPORTANT SAFETY NOTICE”
(pp. 4-5) and “Precautions with regard to safety”
(pp. 6-9) for details on handling the power cord.

Installation

1. Check the shape of the AC

IN terminal on the side of the
projector and the shape of the
power cord connector, and
insert the power cord securely
into the AC IN terminal.

2. Insert the power cord plug into

an electrical outlet.

Removal

1. Check that the MAIN POWER

switch on the projector is at
the OFF position, and then
disconnect the power cord plug
from the electrical outlet.

2. Disconnect the power cord

connector from the AC IN
terminal of the projector.

Attention

Connect all peripheral equipment to the projector
before connecting the projector’s power cord.
(pp. 25-26)

FILTER
CLEANING

OPEN

CLOSE

Power indicator lamp

Advertising