Panasonic PT DW10000U - Manuel (Page 64)

64 – ENGLISH
15. Use ◄► to adjust the width for
correcting the “BRIGHT INSIDE”
setting (0 to 255).
16. Press ▲▼ to select “BRIGHT
OUTSIDE”.
17. Press ENTER.
The “BRIGHT OUTSIDE” adjustment screen
will be displayed.
When “INTERLOCKED” is set to “OFF”,
individual adjustment of “R”, “G” and “B” will be
possible.
18. Press ▲▼ to select an item, and
press ◄► to adjust the setting.
•
•
BRIGHT ADJUST
BRIGHT INSIDE
BRIGHT OUTSIDE
UPPER
LOWER
LEFT
RIGHT
MENU SELECT
ADJUST 0
0
0
0
BRIGHT ADJUST
BRIGHT INSIDE
BRIGHT OUTSIDE
UPPER
LOWER
LEFT
RIGHT
MENU SELECT
ADJUST 0
0
0
0
BRIGHT OUTSIDE
INTERLOCKED
Wh
R
G
B
MENU SELECT
CHANGE
ON
0
0
0
0
BRIGHT OUTSIDE
INTERLOCKED
Wh
R
G
B
MENU SELECT
CHANGE
ON
0
0
0
0
BRIGHT adjustment
(right)
Edge blending width (right) Projection
range
Marker
BRIGHT OUTSIDE
BRIGHT INSIDE
BRIGHT adjustment
(right)
Edge blending width (right) Projection
range
Marker
BRIGHT OUTSIDE
BRIGHT INSIDE
Note
The BRIGHT adjustment is a function for making
the brightening of the BRIGHT level in those areas
where the pictures overlap less conspicuous
when multi-screens have been configured using
edge blending. The optimal point is where, after
the BRIGHT INSIDE has been adjusted, the
compensation amount is the same for the BRIGHT
levels in the areas where the pictures overlap and
where the pictures do not overlap. If, after the
BRIGHT INSIDE adjustment, only the vicinity of
the borders of the areas where the pictures overlap
and where the pictures do not overlap becomes
bright, proceed to adjust the top, bottom, left and
right widths. Alternatively, if only the vicinity of
the borders has darkened as a result of the width
adjustments, proceed with the BRIGHT OUTSIDE
adjustment.
When a rear screen or screen with a high gain is
used, the joints may appear to be discontinuous
depending on the viewing position.
Frame delay
When 1080/60i, 1 080/50i and 1 080/24sF signals are
being input, this simplifies image processing so that
the frame delay for pictures can be shortened.
1. Press
▲▼ to select “FRAME
DELAY”.
2. Press ◄► to switch “FRAME
DELAY”.
The setting will change as follows each time
◄► is pressed.
DEFAULT:
This is the standard setting
SHORT:
This causes the pictures to be delayed after the
audio.
•
•
•
•
•
ADVANCED MENU
DIGITAL CINEMA REALITY
BLANKING
INPUT RESOLUTION
CLAMP POSITION
EDGE BLENDING
FRAME DELAY
RASTER POSITION
MENU SELECT
CHANGE
AUTO
OFF
DEFAULT
ADVANCED MENU
DIGITAL CINEMA REALITY
BLANKING
INPUT RESOLUTION
CLAMP POSITION
EDGE BLENDING
FRAME DELAY
RASTER POSITION
MENU SELECT
CHANGE
AUTO
OFF
DEFAULT
DEFAULT SHORT DEFAULT SHORT
How to use ADVANCED MENU (continued)