For your safety read before operating, Lighting instructions – Empire Comfort Systems DV-55E-5 Manuel d'utilisation

Page 12

Advertising
background image

19563-4-0610

Page 12

FOR YOUR SAFETY READ BEFORE OPERATING

WARNING: If you do not follow these instructions exactly, a fire or explosion

may result causing property damage, personal injury or loss of life.

A. This appliance does not have a pilot. It is equipped with an

ignition device which automatically lights the burner.

Do not try to light the burner by hand.

B. BEFORE OPERATING smell all around the appliance area

for gas. Be sure to smell next to the floor because some gas

is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electrical switch;

do not use any phone in your building.

• Immediately call your gas supplier from a neighbor's

phone. Follow the gas supplier's instructions.

• If you cannot reach your gas supplier, call the fire

department.

C. Use only your hand to push in or turn the gas control knob.

Never use tools. If the knob will not push in or turn by hand,

don't try to repair it; call a qualified service technician. Force

or attempted repair may result in a fire or explosion.

D. Do not use this appliance if any part has been under water.

Immediately call a qualified service technician to inspect the

appliance and to replace any part of the control system and

any gas control which has been under water.

1. STOP! Read the safety information above.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device which

automatically lights the burner. Do not try to light the burner

by hand.

5. Remove control access panel (front panel).
6. Turn gas control knob clockwise

to "OFF."

7. Wait ten (10) minutes to clear out any gas. Then smell for

gas, including near the floor. If you smell gas, STOP! Follow

"B" in the safety information above. If you don't smell gas,

go to the next step.

8. Turn gas control knob counterclockwise

to "ON".

9. Replace control access panel (front panel).
10. Turn on all electric power to the appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the instructions "TO

TURN OFF GAS TO APPLIANCE" and call your service

technician or gas supplier.

OPERATING INSTRUCTIONS

TO TURN OFF GAS TO APPLIANCE

1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to be

performed .

3. Remove control access panel (front panel).

4. Turn gas control knob clockwise

to "OFF." Do not

force.

5. Replace control access panel (front panel).

TOP VIEW

BACK END VIEW

GAS CONTROL LEVER SHOWN

IN "OFF" POSITION

OFF

CONVERTIBLE

REGULATOR

VINYL CAP

VINYL CAP

CONVERTIBLE

REGULATOR

GAS CONTROL LEVER SHOWN

IN "OFF" POSITION

TOP VIEW

BACK END VIEW

LIGHTING INSTRUCTIONS

Advertising