Tweco 75XL Plus PAK Master - Manuel (Page 17)

Manual 0-2807 2-3 INTRODUCTION
2.04 Power Supply Options and
Accessories
NOTE
Refer to Section 6, Parts Lists, for part numbers
and ordering information.
The following are accessories that are available for this
power supply:
A. Single-Stage Filter Kit
A Single Stage In-Line Air Filter which is a pneumatic
dryer/evaporator that installs in the plasma or sec-
ondary compressed air line. Filters moisture, oil, dirt,
chips, rust particles, and other contaminants.
B. High Pressure Regulators
High pressure regulators are available for air and ni-
trogen. The regulators are used to set the proper pres-
sure for the type gas being used.
C. 575V Transformer
This step-down transformer allows the power sup-
ply to operate with 575 VAC three-phase input power.
D. Computer Control Cable (CNC)
The interface cable is available in two lengths, 25 ft
(7.6 m) and 50 ft (15.2 m). The cable is used to inter-
face the power supply with an auxiliary control de-
vice to provide OK-To-Move, ON/OFF signals and
standoff control signals.
E. Single-Phase Input Power Cable (220 VAC)
Input power cable with molded plug for applications
using single-phase 220 VAC input power.
F. Multi-Purpose Cart
Rugged steel cart on easy-rolling rear wheels and
front-mounted swivel casters. Provides maximum
mobility for the power supply and can also serve as
a display cart. Top shelf is 12 " (305 mm) x 20 (508
mm). Steel handle is 30" (762 mm) high.