Rockwell Automation 1769-ADN DeviceNet Modules Installation Instructions - Manuel (Page 9)

Rockwell Automation Publication DNET-IN001B-EN-P - January 2012 9
Chapter
1
Install a 1756 DeviceNet Communication
Module
Topic Page
Installation Summary 11
Determine Module Slot Location 12
Set the Communication Rate 12
Set the Node Address 14
Restore the Factory Default Settings 15
Install the Module 16
Connect the Module to a DeviceNet Network 17
Download the Add-on Profile 18
Connect to the Module via the USB Port 18
Apply Chassis Power and Check Status Indicators 23
Install or Remove the Module Under Power 24
ATTENTION: Environment and Enclosure
This equipment is intended for use in a Pollution Degree 2 industrial environment, in overvoltage Category II applications
(as defined in IEC 60664-1), at altitudes up to 2000 m (6562 ft) without derating.
This equipment is considered Group 1, Class A industrial equipment according to IEC/CISPR 11. Without appropriate
precautions, there may be difficulties with electromagnetic compatibility in residential and other environments due to
conducted and radiated disturbances.
This equipment is supplied as open-type equipment. It must be mounted within an enclosure that is suitably designed for
those specific environmental conditions that will be present and appropriately designed to prevent personal injury
resulting from accessibility to live parts. The enclosure must have suitable flame-retardant properties to prevent or
minimize the spread of flame, complying with a flame spread rating of 5VA or be approved for the application if non-
metallic. The interior of the enclosure must be accessible only by the use of a tool. Subsequent sections of this
publication may contain additional information regarding specific enclosure type ratings that are required to comply with
certain product safety certifications.
In addition to this publication, see the following:
•
Industrial Automation Wiring and Grounding Guidelines, publication 1770-4.1 , for additional installation requirements
•
NEMA Standard 250 and IEC 60529, as applicable, for explanations of the degrees of protection provided by
enclosures