Rockwell Automation 1769-ADN DeviceNet Modules Installation Instructions - Manuel (Page 20)

20 Rockwell Automation Publication DNET-IN001B-EN-P - January 2012
Chapter 1 Install a 1756 DeviceNet Communication Module
To configure RSLinx Classic software to use a USB port, you need to first set up a
USB driver. To set up a USB driver, perform this procedure.
1. Connect your EtherNet/IP module to your computer by installing a USB
cable in your module’s USB port.
The RSLinx Found New Hardware Wizard dialog box appears.
2. Click Install the Software Automatically.
3. Click Next.