Rockwell Automation 1769-ADN DeviceNet Modules Installation Instructions - Manuel (Page 11)

Rockwell Automation Publication DNET-IN001B-EN-P - January 2012 11
Install a 1756 DeviceNet Communication Module Chapter 1
Installation Summary To install a communication module in a 1756 ControlLogix chassis, complete
these steps.
1. Determine Module Slot Location .
2. Set the Communication Rate .
3. Set the Node Address .
4. Install the Module .
5. Connect the Module to a DeviceNet Network .
6. Download the Add-on Profile .
7. Connect to the Module via the USB Port .
8. Apply Chassis Power and Check Status Indicators .
Grounding Considerations
Refer to these publications for grounding guidelines:
• DeviceNet Media Design and Installation Guide, publication
DNET-UM072
• Industrial Automation Wiring and Grounding Guidelines, publication
1770-4.1
ATTENTION: This equipment is not resistant to sunlight or other sources of UV radiation.
ATTENTION: Prevent Electrostatic Discharge
This equipment is sensitive to electrostatic discharge, which can cause internal damage and affect normal operation.
Follow these guidelines when you handle this equipment:
•
Touch a grounded object to discharge potential static.
• Wear an approved grounding wriststrap.
• Do not touch connectors or pins on component boards.
• Do not touch circuit components inside the equipment.
•
Use a static-safe workstation, if available.
•
Store the equipment in appropriate static-safe packaging when not in use.