Rockwell Automation 1769-ADN DeviceNet Modules Installation Instructions - Manuel (Page 36)

36 Rockwell Automation Publication DNET-IN001B-EN-P - January 2012
Chapter 2 Install a 1769 DeviceNet Communication Module
Download the Add-on
Profile If you are using a later firmware revision for the communication module than
recognized in the most current version of RSLogix 5000 software, you may need
to download the Add-on Profile (AOP) for the communication module so it can
be recognized in the Controller Organizer.
1. Locate the module AOP at http://www.rockwellautomation.com/
support/controlflash/LogixProfiler .
2. Click the file to download it.
3. Enter your RSLogix 5000 software serial number and click Qualify for
Update.
4. Download and extract the zipped files to a temporary directory.
5. Shut down any instances of RSLogix 5000 software that are currently
running.
6. In the temporary directory, double-click the MPSetup.exe file and follow
the onscreen instructions to install the AOP.
Apply Chassis Power and
Check Status Indicators Before you apply power, you must install and mount a CompactLogix controller
and Compact I/O power supply on the DIN rail.
To apply power, follow these steps.
1. Apply chassis power.
2. Check the power supply and status indicators to determine that the power
supply and module are operating properly.
Replace a Module within a
System
The module can be replaced while the system is mounted to a panel or DIN rail.
1. Remove power.
2. Remove the DeviceNet cable from the module by removing the DeviceNet
connector.
3. Remove the upper and lower mounting screws from the module or open
the DIN latches by using a screwdriver.
IMPORTANT You need a Rockwell Automation MySupport account to
download the AOP. If you do not have one, follow the steps on the
MySupport website to obtain an account.
ATTENTION: Do not remove or replace this module while power is
applied. Interruption of the backplane can result in unintentional operation
or machine motion.