Panasonic AJ-B95 - Manuel (Page 52)

52
Operation methods
Analog component signals, analog composite signals
and serial component digital signals can be played
back and output using VTR1 and VTR2.
Playback using VTR1, VTR2
1
Set the OPERATION MODE mode switch (page
13) to SEPARATE.
2
Select AUTO as the setup menu item No.013 (PB
FORMAT) setting. If MANU has been selected,
select the setup menu item No.012 (SYS
FORMAT) setting which matches the format of the
tape to be played back.
3
4
When analog video signals are to be output, select
whether analog component signals or analog
composite signals are to be output using setup
menu item No.670 (V IN SEL).
5
When serial component digital signals are to be
output, select the VTR for SDI output using setup
menu item No.174 (SDI OUT). (Either VTR1 or
VTR2 is selected as the VTR since there is only
one SDI output system.)
6
Set the ANALOG AUDIO OUT switch and connect
the signals to the rear panel connectors as
described on page 27.
7
If necessary, input the reference video signal to the
REF VIDEO IN connector, and use the encoder
control on the side panel to perform the encoder
and/or system adjustments. (See page 23)
8
Select the VTR using the VTR1 or VTR2 button,
and press the PLAY button.
9
To stop playback, select the VTR whose playback
is to be stopped, and press the STOP ([SHIFT] +
[PLAY]) button.
Playback can also be stopped by pressing the FF
button and REW button at the same time.
VTR2 stops when the ALL STOP button is
pressed.
Select “525” or “625” as the setup menu item
No.070 (TV SYSTEM) setting to match the tape to
be played back.
<Notes>
O
When the “525” or “625” setting has been
changed, turn off the power and then turn it back
on again.
O
VTR1 and VTR2 cannot be set to different TV
systems.