Panasonic AJ-B95 - Manuel (Page 41)

The underlining indicates the factory setting.
500 VITC BLANK
0000
0001 BLANK
THRU
This selects whether to output the VITC signal at the positions
which have been set by setup menu item No.501 (VITC POS-1)
and No.502 (VITC POS-2).
0: The VITC signal is not output.
1: The VITC signal is output.
[ [
503 TCG REGEN
0000
0001
0002 TC&UB
TC
UB
This selects the signal to be regenerated when the TCG (time
code generator) is in the regeneration mode.
0: Both the time code and user’s bit are regenerated.
1: Only the time code is regenerated.
2: Only the user’s bit is regenerated.
[ [
504 REGEN MODE
0000
0001
0002
0003
AS&IN
ASSEM
INSRT
SW
This selects when the time code is to be regenerated during
automatic editing (assemble editing or insert editing).
0: The time code is regenerated in assemble editing or insert
editing.
1: The time code is regenerated in assemble editing.
2: The time code is regenerated in insert editing.
3: The time code regeneration accords with the REGEN/PRESET
switch position.
[
501 VITC POS-1
(525i mode) 0000
0006
0010
10L
16L
20L
This selects the position where the VITC signal is inserted.
<Note>
The same line as the one selected by setup menu item No.502
(VITC POS-2) cannot be set.
[ [
(625i mode) 0000
0004
0015
7L
11L
22L
502 VITC POS-2
(525i mode) 0000
0008
0010
10L
18L
20L
This selects the position where the VITC signal is inserted.
<Note>
The same line as the one selected by setup menu item No.501
(VITC POS-1) cannot be set.
[ [
(625i mode) 0000
0006
0015
7L
13L
22L
Item Setting
No.
Superimposed
display
No.
Superimposed
display
Description of setting
V
T
R
1
V
T
R
2
41
Setup menus
TIME CODE menu