Panasonic AJ-B95 - Manuel (Page 38)

The underlining indicates the factory setting.
370 BEEP
0000
0001
0002
0003
OFF
ENTRY
ALL1
ALL2
This selects whether the confirmation tone is to be sounded.
0: The confirmation tone does not sound.
1: The confirmation tone is sounded when registering is performed
or when an error or warning has occurred.
2: The confirmation tone is sounded when registering is
performed, when an edit IN or OUT point is passed or when an
error or warning has occurred.
3: The confirmation tone is sounded when registering is
performed, when an edit OUT point is passed or when an error
or warning has occurred. It does not sound when an edit IN
point is passed.
374 EDL AUTO CLR
0000
0001 OFF
ON
This selects whether to clear the first event and overwrite the
subsequent events successively when the EDL is full with
registered events.
0: Events cannot be overwritten.
1: Events can be overwritten.
371 SV-UNLK EDIT
0000
0001
0002
EDIT
ABORT1
ABORT2
This selects in what editing mode the editing is to be suspended
when servo lock is not engaged.
0: Editing is not suspended and is continued.
1: Editing is suspended when the servo lock is not engaged in the
editing run-up period.
2: Editing is suspended when the servo lock is not engaged in the
editing run-up period or after edit recording mode has been
suddenly established.
372 SYNCHRO EDIT
0000
0001 OFF
ON
This selects whether editing is to be suspended if phase
synchronization cannot be achieved at an accuracy of ±0 frame
when the SYNCHRO setting is ON.
0: Editing is not suspended.
1: Editing is suspended.
373 SYNCHRO
0000
0001 VTR1
VTR2
This sets the VTR for which the phase is synchronized.
0: Phase is synchronized for VTR1.
1: Phase is synchronized for VTR2.
375 SPLIT EDIT
0000
0001
AUDIO
VIDEO
This selects the split editing reference.
0: The video edit points are used as the reference for audio split
editing.
1: The audio edit points are used as the reference for video split
editing.
[
[
[
[
[
377 1ST EDIT TC This selects the time code preset value during 1ST EDIT.
00:00:00:00 to 23:59:59:29 (525i mode)
00:00:00:00 to 23:59:59:24 (625i mode)
[
378 1ST EDIT UB This selects the user’s bit preset value during 1ST EDIT.
00:00:00:00 to FF:FF:FF:FF
[
[
376 1ST EDIT DUR
0000
0001
26s
T-END
This selects the time during which the black burst signal is to be
recorded during 1ST EDIT.
0: The signal is recorded for 26 seconds, after which the tape is
reversed for 3 seconds and stopped. The point at which the
tape has stopped serves as the point which is set by 1ST EDIT
PRESET.
1: The signal is recorded to the tape end or the position where the
tape is stopped by ALL STOP. When it is recorded to the tape
end, the tape is automatically reversed to the 1ST EDIT
PRESET position.
[
Item Setting
No.
Superimposed
display
No.
Superimposed
display
Description of setting
V
T
R
1
V
T
R
2
38
Setup menus
EDIT menu