Initial setup, Turn on the tv and the unit, Setting the clock – Curtis DRC8335 Manuel d'utilisation

Page 12: Searching for channels

Advertising
background image

12

Initial setup

Turn on the TV and the unit

1. Turn on the unit by pressing ON/STANDBY or ON•OFF.
2. Turn on the TV and select the AV input mode connected

with the unit’s output signal. To do so, you usually press
the AV or INPUT button on the TV remote control until
you get to the video input channel that matches how the
DVD recorder is connected to the TV. When you are on
the right channel, you can see the unit’s player menu.

Setting the clock

1. Press SETUP on the remote control to access the player

menus.

2. Press

or

to highlight “Setup”and then press OK.

3. Press

or

to highlight “System”and then press OK.

4. Press

or

to highlight “Clock”and then press OK.

5. Highlight “Year”, “Month”, “Day” and “Time” by

pressing

or

.

6. Press OK and then set the value by pressing

or

.

For the “Time” setting, press

or

to select among the

hour, minute and AM/PM options before setting their
values.

7. Press OK after the setting is done. Press EXIT/CLEAR to

exit the clock setting menu.

Since access to a TV’s video input channel varies
from one manufacturer to the next, it is difficult
to provide specific instructions for your particular
brand. Please refer to the user manual of your TV.

Searching for channels

1. Press SETUP to access the player menus.
2. Press

or

to highlight “Setup”and then press OK.

3. Press

or

to highlight “TV Channel Setup”and then

press OK.

4. Press

or

on the action bar at the bottom of the screen

to highlight “Scan”and then press OK.

5. Select the input signal type, if necessary, between “Air”

(if antenna is connected) and “Cable” (if cable is
connected) and then press OK. Highlight “Yes” and then
press OK to continue.

6. The scan operation will overwrite any existing channel

table. Highlight “Yes” and then press OK to continue.
Automatic channel search will begin.

When the channel search reaches 100%, press OK.

If no channel list appears, check the ANTENNA/CABLE
input jack to make sure the RF coaxial cable is properly
connected.

AV/INPUT

DRC8335_EN(verB) 7/23/07 3:36 PM Page 14

Advertising