Labconco ScrubAi Pipette Washer/Dryer 46120 Series - Manuel (Page 8)

Chapter 2: Prerequisites
Product Service 1-800-522-7658
4
4
The heated models do not require a heated water source for the tap or the pure
water but using heated water will allow the washer to reach the 140°F (60°C)
wash temperature faster.
Water pressure for both tap and pure water must be between 8-120 psi (55-827
kPa) at the washer and provide a minimum of 1.33 gallons (5.0 liters) per minute
flow rate.
By using the factory- installed quick connect hose coupling, the tap water/drain
hoses can easily be connected or disconnected to a sink faucet. If using the quick
connect hose coupling, a sink with a drain and threaded faucet is required. See the
illustration that follows. Since the quick connect hose assembly length is 6’
(1.8m) the installation should be within this distance to the faucet.
EXTERNAL
THREADED
FAUCET
AERATOR
ADAPTER
(SUPPLIED)
HOSE END
COUPLING
INTERNAL
THREADED
FAUCET
AERATOR
ADAPTER
(SUPPLIED)
If a dedicated tap water supply is preferred a shut-off valve should be installed in
the water supply line plumbed for the washer.
Electrical Requirements
Minimum requirements for an outlet is a 15 Amp circuit breaker or fuse for
models rated at 115V (60 Hz) or an 8 Amp circuit breaker or fuse is required for
230V (50/60 Hz) models. The 115V models are equipped with a 15 Amp NEMA
5-15P plug. 230V models are available with a NEMA 6-15P plug for use in the
United States, a PS 1363 plug for use in the United Kingdom, a CEE 7/7 plug for
use in Europe, a CHI-10P plug for use in China or a SANS164-1 plug for use in
India. It may be necessary to remove the plug and install a different one to match
the available receptacle if one of these models does not meet your needs.
Drain Requirements
The Washer/Dryer is designed to use air pressure to drain the washer. If using the
quick connect hose coupling, a sink with a drain and threaded faucet is required.
Since the quick connect hose assembly length is 6’ (1.8m) long the installation
should be within this distance to the faucet.