Labconco ScrubAi Pipette Washer/Dryer 46120 Series Manuel d'utilisation
Page 5
Product Service 1-800-522-7658
1
C
C
H
H
A
A
P
P
T
T
E
E
R
R
1
1
I
I
N
N
T
T
R
R
O
O
D
D
U
U
C
C
T
T
I
I
O
O
N
N
Congratulations on your purchase of a Labconco ScrubAir™ Pipette
Washer/Dryer. The ScrubAir Pipette Washer/Dryer uses water and compressed
air to wash, rinse and dry volumetric pipettes ranging in size from .135” (3.4 mm)
stem diameter and 7.5” (190.5 mm) long up to .34” (8.6 mm) stem diameter and
25” (635mm) long. The ScrubAir is available in 115V or 230V models with and
without a 750 watt heater which can heat the water and dry air up to 140°F
(60°C). The heated models also come with an additional water inlet valve for pure
water connections if pure water rinsing is desired.
The Pipette Washer/Dryer graphic display shows operational information during
set up and displays of the cycle segment and time remaining during the wash
cycle. The transparent acrylic cover allows you to visually monitor the operation
of your washer. You can select pre-programmed wash cycles or program
customized wash cycles to meet your requirements.
The start time can be delay by up to 8 hours. The wash times can be programed
from 0 to 8 hours. Rinse cycles can be set from 0 to 10 with rinse times from 0 to
4 hours each.
Safety Symbols
Your Pipette Washer/Dryer was designed with safety in mind, however conditions
may exist that could be hazardous.
Throughout this manual potentially hazardous conditions are identified using the
following words and symbols.
CAUTION: This is the safety alert symbol. It is used to alert
you to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible injury or
death.
PRUDENCE: Ceci est le symbole d’alerte de sécurité. Il est
utilisé pour vous alerter aux risques de dommages corporels
potentiels. Obéissez à tous les messages de sécurité qui suivent
!