Labconco ScrubAi Pipette Washer/Dryer 46120 Series - Manuel (Page 25)

Chapter 4: Using Your Washer/Dryer
Product Service 1-800-522-7658
21
4. Once a program is selected, if no modifications to the program are necessary,
press RUN/CANCEL to begin the cycle.
5. If modifications to the program are necessary or you want to see the
parameters that are entered into the program, press SELECT and the display
will show Delay Time 0:00. If you would like to delay the start time of the
wash cycle press SELECT. The time will change in 1 minute increments each
time SELECT is pressed. Press and hold SELECT to scroll the time faster, up
to a maximum of 8:00 hours and then it will wrap back to 0:00.
6. Press MENU and the display will show Wash Time 0:05. If you would like to
change the wash time of this cycle press SELECT. The time will change in 1
minute increments each time SELECT is pressed. Press and hold SELECT to
scroll the time faster, up to a maximum of 8:00 hours, and then wrap back to
0:00.
7. Press MENU and the display will show # of Rinses 3. If you would like to
change the number of rinses for this cycle press SELECT. The number will
increase 1 each time SELECT is pressed. Press and hold SELECT to scroll
through faster, up to a maximum of 10, and then wrap back to 0.
8. Press MENU and the display will show Rinse Time 0:04. If you would like to
change the rinse time of this cycle press SELECT. The time will change in 1
minute increments each time SELECT is pressed. Press and hold SELECT to
scroll the time faster, up to a maximum of 4:00 hours, and then wrap back to
0:00. The rinse time selected will be the rinse time for each rinse, so if 4 hours
and 10 rinses are selected, the total time added will be 40 hours.
9. Press MENU and the display will show Dry Time 2:30. If you would like to
change the dry time of this cycle press SELECT. The time will change in 1
minute increments each time SELECT is pressed. Press and hold SELECT to
scroll the time faster, up to a maximum of 8:00 hours, and then wrap back to
0:00.
10. Press MENU and the display will show Lock . If the lock feature is not
required, press MENU the display to return to the program menu. If you
would like to lock the program’s settings so that it cannot be inadvertently
revised press SELECT. The lock symbol will close. Press MENU. The display
will show the program that was just modified and the locked symbol. The only
active button will be RUN/CANCEL. To unlock the program, press and hold
MENU for 15 seconds, the lock symbol will disappear.
11. Once the display shows the modified program the Washer/Dryer is ready to
go. Press RUN/CANCEL to begin.
Interrupting a Wash Cycle
To temporarily pause a wash cycle, simply press the RUN/CANCEL button, press
again to resume. The wash cycle will resume where it was interrupted. The wash
cycle can also be paused by slowly raising the Clear Cover, which will actuate the
lid sensor. Hold the Clear Cover over the tank for a few seconds to allow some of
the water to drain off before removing completely. When removing the clear
cover completely, slowly rotate the top of the cover forward as you raise it. This
will allow more of the excess water to drain back into the tank. Reverse this
process when replacing the Clear Cover and the wash cycle will resume.