Labconco ScrubAi Pipette Washer/Dryer 46120 Series Manuel d'utilisation
Page 7
Product Service 1-800-522-7658
3
C
C
H
H
A
A
P
P
T
T
E
E
R
R
2
2
P
P
R
R
E
E
R
R
E
E
Q
Q
U
U
I
I
S
S
I
I
T
T
E
E
S
S
Before you install the Pipette Washer/Dryer, prepare your site for installation.
Carefully examine the location where you intend to install the Pipette
Washer/Dryer. Be sure the area is level and of solid construction. In addition a
water source, a drain, electrical and compressed air sources must be located near
the installation site.
Refer to Appendix C:ScrubAirPipette Washer/Dryer Specifications for complete
Pipette Washer/Dryer electrical and environmental conditions, specifications and
requirements.
The ScrubAir Pipette Washer/Dryer is equipped with a single water supply/drain
hose quick connector that can easily be attached to your sink faucet. If preferred,
the ScrubAir Pipette Washer/Dryer can be installed using dedicated water supply
and drain piping.
CAUTION: If the unit is not operated as specified in this
manual it may impair the protection provided by the unit.
PRUDENCE: Si l'unité n'est pas utilisée comme spécifié dans
ce manuel il peut diminuer la protection fournie par l'unité.
Water Requirements
The water supply for non-heated models can be tap or purified water. An existing
hot water supply may be used as the water source. Though not required, Labconco
recommends the inlet water temperature be greater than 120°F (49°C). Hotter
water will produce better washing results but should not exceed 140°F (60°C).
The heated models have and additional water inlet valve to allow for connection
to a purified water source. A 3/8" (9.6 mm) O.D. x 6’ (1.8m) long polyethylene
tube is attached to the rear of the ScrubAir Pipette Washer/Dryer (marked “P”) for
connection to a dedicated pure water source. This tube can be shortened as
required, a shut off valve is recommended.
!